EasyManua.ls Logo

Siemens Gigaset C590 - Initial Battery Charging and Discharging

Siemens Gigaset C590
75 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
First steps
Gigaset C590 / IM-NORD EN / A31008-M2101-R201-1-SM19 / starting.fm / 29.06.2009
Version 4, 16.09.2005
Initial charging and discharging of the batteries
The correct charge level can only be displayed if the batteries are first fully
charged and discharged.
¤ Place the handset in the base/charging
cradle for 10 hours.
¤ Then remove the handset
from the base/charging
cradle and do not replace it
until the batteries are fully
discharged.
10h
Please note
u After the first battery charge and discharge you may replace your hand-
set in the base/charging cradle after every call.
u Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u The batteries may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the batteries will decrease for tech-
nical reasons.

Table of Contents

Other manuals for Siemens Gigaset C590

Related product manuals