9
First steps
Gigaset E365 / AUS / A31008-M1806-C401-1-7619 / starting.fm / 10.11.2008
Version 4, 16.09.2005
Connecting the base station
¤ First connect the mains adapter and
then the phone jack as shown below
and place the phone cord in the cord
recess.
1 Underside of the base (section)
2 Mains adapter 230 V
3 Phone jack with phone cord
Please remember:
u Keep the mains adapter plugged in at
all times for operation as the phone
does not work without mains
connection.
u If you buy a replacement phone cord
from a store ensure that the phone jack
is connected correctly.
Setting up the handset for use
Fitting the batteries and closing the
cover
¤ Fit the batteries with the correct polar-
ity (see diagram).
The polarity is indicated in the battery
compartment.
¤ First align the notches on the side of
the battery cover with the protrusions
of the inside of the casing.
¤ Then press down the cover so that it
clicks into place.
Correct phone jack assignment
1unused
2unused
3a
4b
5unused
6unused
1
3
2
1
1
1
3
2
1
4
5
6
Caution:
Use only the rechargeable batteries recom-
mended by Gigaset Communications GmbH
*
on page 39. In other words, never use a con-
ventional (non-rechargeable) battery or other
battery types as this could result in significant
health risks and personal injury. For example,
the outer casing of the batteries or accumula-
tors could be destroyed or the batteries could
explode. The phone could also malfunction or
be damaged as a result of using batteries that
are not of the recommended type.
* Gigaset Communications GmbH is a
trademark licensee of Siemens AG.
To Next Page
Loading...
