EasyManua.ls Logo

Siemens Gigaset E365 - Appendix; Symbols and Typographical Conventions Used; Care; Contact with Liquid

Siemens Gigaset E365
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
36
Appendix
Gigaset E365 / AUS / A31008-M1806-C401-1-7619 / appendix.fm / 10.11.2008
Version 4, 16.09.2005
Appendix
Symbols and typographical
conventions used
This section explains the meaning of cer-
tain symbols and typographical conven-
tions that are used in this user guide.
~ Enter digits or letters.
§Menu§ The display functions currently
in the bottom display line are
shown in reverse video. Press
the relevant display key to
launch the function.
q Press the top or bottom of the
control key, e.g. when
scrolling.
c / Q / P etc.
Press the illustrated key on the
handset.
External Calls / Internal Calls (example)
Select one of the menu func-
tions (External Calls or Internal
Calls) from the list and
press
§OK§.
§§Menu§ ¢ Audio Settings ¢ §OK§ ¢ Ringer
Melody (example)
¢ §OK§
Press
§Menu§. Select Audio Set-
tings using q and press
§OK§.
Select Ringer Melody using q
and press
§OK§.
Care
¤ Wipe the base station and handset with
a damp cloth (do not use solvent) or an
antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
¤ Switch the handset off and remove
the batteries immediately.
¤ Allow the liquid to drain from the hand-
set.
¤ Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours
(not in a microwave, oven, etc.).
¤ Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will gener-
ally be able to use it again.
Questions and answers
If you have any questions about using
your phone, visit us anytime at
www.gigaset.com/customercare
.
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥ Press and hold the end call key a.
2. The battery is flat.
¥ Charge the battery or replace it
(page 9).
The handset does not respond to a key
press.
The keypad lock is activated.
¥ Press and hold the hash key
#
(page 15).
!

Table of Contents

Related product manuals