Siemens Gigaset S455 - Setting up the Handset for Use

7
First Steps
Gigaset S455 AM / GBR / A31008-M1714-L101-1-7619 / starting.fm / 31.08.2006
Please note:
u The mains adapter must be always
connected, as the phone will not oper-
ate without mains connection.
u If you buy a replacement phone cord
from a store, ensure that the phone
jack is connected correctly.
Setting up the handset for use
Inserting the batteries
¤ Fit the batteries with the correct polar-
ity (see diagram).
The polarity is indicated in/on the battery
compartment.
Closing the battery cover
¤ First align the notches on the side of
the battery cover with the lugs on the
inside of the casing.
¤ Then press the cover so that it clicks
into place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤ Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
Correct phone jack assignment
1unused
2unused
3a
4b
5unused
6unused
Caution:
Use only the rechargeable batteries recom-
mended by Siemens (page 51). Never use con-
ventional (non-rechargeable) batteries or
other battery types as this may cause signifi-
cant damage to health and property. For
example, the outer casing of the batteries
could be destroyed or the batteries could
explode. The phone could also malfunction or
be damaged as a result of using batteries that
are not of the recommended type.
3
2
1
4
5
6