54
Notes on the operating instructions
Gigaset S455 AM / GBR / A31008-M1714-L101-1-7619 / appendix.fm / 31.08.2006
Writing and editing a text
message
The following rules apply when writing a
text message:
u Control the cursor with u v t
s.
u Characters are added to the left of the
cursor.
u Press the star key
*
to show the
table of special characters.
u The first letter of the name of directory
entries is automatically capitalised, fol-
lowed by lower case letters.
Entering special characters
You can call up the table of special charac-
ters when writing an SMS using the
*
key. Select the required character and
insert it with
§Insert§.
Writing an SMS/name
(without predictive text)
Press the hash key # briefly to switch
from "Abc" mode to "123" and from "123"
to "abc" and from "abc" to "Abc" (upper
case: 1st letter upper case, all others lower
case). Press the hash key # before
entering the letter.
The following applies when writing an
SMS:
u The display shows whether upper case,
lower case or digits is selected. "Abc",
"abc" or "123" appears at the top right
of the display.
u When you press a key and hold it, the
characters of that key appear in the
bottom display line and are high-
lighted one after the other. When you
release the key the highlighted charac-
ter is inserted into the input field.
Writing an SMS (with predictive text)
EATONI predictive text helps you when
you are writing an SMS.
Each key between Q and O is
assigned several letters and characters
(see the character set tables, page 54).
These appear in a selection line immedi-
ately under the text panel (above the dis-
play keys) as soon as you press a key. The
letter you are most likely looking for is
reverse-highlighted and is at the begin-
ning of the selection line. It is copied into
the text panel.
1 EATONI is activated
2 Upper/lower case or digits
3SMS text
4Selection line
If this letter is the one you want, confirm
it by pressing the next key. If it is not the
one you want, briefly press the hash
key # repeatedly until the required let-
ter is reverse-highlighted on the display
line and copied into the text panel.
If you press and hold the hash key #
you switch from "Abc" mode to "123" and
from "123" to "abc" and from "abc" to
"Abc".
Deactivating/activating predictive text
Requirement: You are writing an SMS.
§Options§ Press the display key.
Predictive Text
Select and press
§OK§ (=on).
a Press the end call key briefly
to return to the text panel.
Enter the text.
3
1
2
4
612(1) Ç Abc
Hello Peter, I cannot come
today. Ic
hgi
X Options
‰
To Next Page
Loading...
