Section 8: Service, Supplies, and Replacement Parts, Page 8—7
Hematek Pump Tube Set
The Pump Tube Set consists of three tubes, each labeled with an identifying number
specific to the reagent to be carried in the tubing. Each tube is a specific diameter and
length to ensure precise measurement of the reagents. The tubing is made of a special type
of rubber that is resistant to leaching and brittleness.
Hematek Underplaten Tubing
The Underplaten Tubing is available for periodic replacement. The tubing set consists of
three tubes of equal diameter and length and, therefore, are not specific to a reagent.
Ordering Information for Supplies and Replacement Parts
To order the following Hematek brand products, contact your local technical support
provider or distributor.
Part Number Description
4481 Hematek Stain Pak – Wright’s Stain
4405 Hematek Stain Pak – Wright-Giemsa Stain
4482
A Hematek Pump Tube Set
4
483
A Hematek Cannula Set
4
484
A Hematek Underplaten Tubing
40151108 Line fuse – 1.0 amp, 5mm x 20mm, Type T
94000787
POWER Light Assembly (Green)
94001073
LOW STAIN Light Assembly (Yellow)
To Next Page
Loading...
