How to turn on a Siemens Handsets when the display is blank?
If your Siemens Handsets display is blank, it could be that the handset is switched off or the battery is empty. Press the On-hook key until you receive confirmation. If that doesn't work, charge or replace the battery.
What does it mean when my Siemens HiPath 500 says 'Base 1 Outgoing and incoming calls and activation/deactivation are not possible'?
If your Siemens Telephone displays 'Base 1 Outgoing and incoming calls and activation/deactivation are not possible,' it means the handset is blocked. Remove the battery from the handset and then re-insert it.
What does 'Time exceeded' mean on my Siemens HiPath 500 Telephone?
The 'Time exceeded' message on your Siemens Telephone indicates that the maximum input time was exceeded, or the On-hook key was not pressed. Avoid long pauses between keystrokes and press the On-hook key.
What to do if my Siemens HiPath 500 Telephone shows 'Connect' but there is no dial tone?
If your Siemens Telephone displays 'Connect' immediately after pressing the Talk key, but there's no dial tone and you can't make calls, it could be that the communication system is currently being used by other users. Try repeating the call later.
What does it mean when the line 'Base n' flashes on my Siemens Telephone?
When the line "Base n" flashes on your Siemens Telephone, it indicates that the handset is either outside the base radio range, the radio signals are too weak, the handset is not registered, or the intervals between synchronization attempts are too long. Try moving closer to the base radio range or changing your position. You may also need to register the handset or switch it off and on again.
Why is there no sound during a call on my Siemens HiPath 500 Telephone?
If you can't hear anything during a call on your Siemens Telephone, it's possible that the microphone and receiver are muted. This can happen if the "R key" was pressed accidentally. Press the "Delete" display key to re-activate the microphone and the receiver.
Why can't I dial a phone number on my Siemens HiPath 500 Telephone?
If you are unable to dial a phone number on your Siemens Telephone, the handset might be locked. Try unlocking the handset.
What to do if my Siemens Telephone doesn't react to keystrokes?
If your Siemens Telephone isn't responding when you press a key, it could be that the keypad lock is activated, or the key is stuck. Try pressing the Hash key until you receive confirmation. Also, make sure the key is not physically stuck.
How to fix a Siemens Telephone with no display?
If your Siemens Telephone display is blank, it could be due to the handset not being switched on or the battery being empty. Try pressing the On-hook key until you receive confirmation. If that doesn't work, charge or replace the battery.
To Next Page
General