HSAAP_Installing.fm
A31003-W1110-U101-1-7619, February 2007
HiPath Wireless Standalone Access Point V1.0, Getting Started Guide
49
Installing and configuring the Standalone Access Point
Understanding Standalone Access Point LED status
4.3 Understanding Standalone Access Point LED status
The description below assumes the software uses a timer and multiple phases to simulate LED
"blinking" on all three LEDs. For example, an LED status of "Red" means that the LED is solid-
colored "Red", and an LED status of “Off/Green/Off” indicates that the LED is “Off” for the first
phase, is “Green” for the second phase, and is “Off” for the third phase.
Table 12 Standalone Access Point LED status definitions
Left LED
Status
Center
LED
Status
Right LED
Status
Access Point Status
Off Off Off Powered-off
Off Green Off Beginning of Power-On-Self-Test (POST) (0.5s)
Off Off Off POST
Off Red Off Failure during POST
Green Off Green Random delay (state shown only after a vulnerable reset)
Green/Off Off/Green Green/Off Vulnerable time interval (the Standalone Access Point
resets to factory default if powered-off for three
consecutive times during this state). No vulnerable
period when Standalone Access Point is resetting to
factory defaults.
Green/Off/
Off
Off/
Green/Off
Off/Off/
Green
Resetting to factory defaults announcement (replaces
vulnerable period). This pattern is repeated twice to
notify the operator when the factory configuration is
restored.
Off Orange
(Green +
Red)/
Green
Off Attempting to obtain IP address via DHCP
Off Off/Green Off Obtained IP address, attempting to join the cluster
Green
when
802.11b/g
enabled
Off
otherwise
Green Green when
802.11a
enabled
Off
otherwise
Member of cluster, radios enabled per user settings
To Next Page
Loading...
