Siemens HiPath - A Appendix: Log Codes and Messages

HSAAP_Appendix_log_codes.fm
A31003-W1110-U101-1-7619, February 2007
HiPath Wireless Standalone Access Point V1.0, Getting Started Guide
59
Appendix: Log codes and messages
A Appendix: Log codes and messages
Listed below are the log codes and messages provided by the Standalone Access Point.
Event
Code (1
byte)
GUI Log Message Comments
1 Reboot caused by "power loss" / "watchdog
timeout" / "software crash" / "Cli
Command." / …
Gives out access point reboot reason
2 Vulnerable time started after "2"
interruptions
Start of Vulnerable time, with previous
power interrupt during 2 consecutive
vulnerable time
3 Vulnerable time ended with no interruptions End of Vulnerable time
4 Configuration restored to factory defaults by
hardware reset
5 Cluster-VNS1 state changed to "Master" /
"Slave" / "Registering"
SIAPP major state change
6 Slave AP with IP "10.2.102.10" and MAC
"00-0F-C8-F0-1A-E6" accepted in the
cluster-VNS1
Master reports new slave accepted
7 Slave AP with IP "10.2.102.10" and MAC
"00-0F-C8-F0-1A-E6" removed from the
cluste-VNS1
Master reports slave removed
8 Client "00-0F-DD-F0-1A-E6" associated
with VNS1 BSSID "00-0F-C8-F0-1A-E8"
9 Client "00-0F-DD-F0-1A-E6" disassociated
from VNS1 BSSID "00-0F-C8-F0-1A-E8"
10 Client "00-0F-DD-F0-1A-E6"
(re)association denied by VNS1 BSSID "00-
0F-C8-F0-1A-E8"
11 Client "00-0F-DD-F0-1A-E6" reassociated
with VNS1 BSSID "00-0F-C8-F0-1A-E8" on
this AP from BSSID "00-0F-C8-F0-1A-D0"
12 Client "00-0F-DD-F0-1A-E6" moved from
VNS1 BSSID "00-0F-C8-F0-1A-E8" on this
AP to BSSID "00-0F-C8-F0-1A-D0"
13 User "admin" successfully logged in
14 User "admin" denied log in
Appendix