Appendix: Log codes and messages
A31003-W1110-U101-1-7619, February 2007
60 HiPath Wireless Standalone Access Point V1.0, Getting Started Guide
HSAAP_Appendix_log_codes.fm
Table 13 Log codes and messages
15 Password for user "admin" successfully
changed
16 Configuration changed successfully
17 Configuration downloaded successfully Bulk configuration downloaded
18 Configuration restored to factory defaults by
software reset
19 Firmware upgraded successfully
20 BootROM upgraded successfully
21 Non-volatile log cleared
22 Debug info: “SIAPP 87 R0->M2”
23 Start checking for radar interference on
channel 5300
24 Finished checking for radar interference on
channel 5300
25 Radar detected. Switch to auto channel
select
26 Auto channel select found channel 5300
27 AP crash reaches a limit of 4 times
Event
Code (1
byte)
GUI Log Message Comments
To Next Page
Loading...
