Siemens HN678G4.1 - Customer Service Information

Rails en
35
24 Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
24.1 Detaching the rails
WARNING‒Risk of burns!
The shelf supports get very hot
▶
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
1.
Lift the rail forwards slightly and detach it ⁠.
2.
Push the entire rail backwards and take it out ⁠.
3.
Clean the rail.
→"Cleaning products", Page28
24.2 Fitting the retainers
The retainers may fall out when you detach the rails.
Note:
The retainers at the front differ from those at the rear.
1.
Hook the front retainers with the hook into the round
hole at the top and set them at a slight angle ⁠.
2.
Hook the front retainers in at the bottom and
straighten them ⁠.
3.
Hook the rear retainers with the hook into the top
hole and push them into the bottom hole ⁠.
24.3 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both pull-out rails, ensure that you can pull them
forwards and out.
1.
Hook the rear shelf support into the retainers at the
top and bottom and pull it forwards ⁠.
2.
Hook in the rail at the front and press it down .