6
319
HOTEL SOLUTION™
Room operator unit
Room operator unit with
built-in sensor
HTC3.1/A
HTC3.1S/A
Room unit for operation of the individual room control system in hotel rooms
• Displays room temperature setpoint and setpoint adjustment
• Individual setpoint adjustment with "plus" and "minus" membrane switches
• Individual manual fan-speed selection for fan control (up to 3 speeds)
• Membrane switch for selection of "Auto" mode
• Room temperature detected with connected temperature sensor
• Room temperature detected with built-in temperature sensor (HTC3.1S/A)
Application
The HTC3.1A and HTC3.1S/A room operator units are used in conjunction with a
HRC3.. room controller. The room operator unit detects the temperature and trans-
mits it to the HRC3.. room controller for room temperature control.
The room operator unit indicates the operating mode in the hotel room and can be
used to operate the fan coil unit, either manually or automatically via the connected
room controller.
CM2N6319en
31.07.2008
Building Technologies
To Next Page
Need help?
General
