Siemens HCP User Manual

SiemensSiemens
SiemensSiemens
Siemens
Industry Industry
Industry Industry
Industry
,,
,,
,
Inc. Inc.
Inc. Inc.
Inc.
Building Building
Building Building
Building
TT
TT
T
ecec
ecec
ec
hnologies Dihnologies Di
hnologies Dihnologies Di
hnologies Di
visionvision
visionvision
vision
P/N 315-034860-13
Intelligent Control Point
Installation Instructions
Model HCP
INTRODUCTION The Model HCP Intelligent Control Point from Siemens
Industry, Inc. provides remote, independent control of
any of the following:
1. A notification appliance circuit (NAC)
2. A telephone zone (XLS only)
3. A speaker zone (25V or 70.7V RMS) (XLS only,
FV2025/2050, FV922/924)
The HCP communicates through the DLC device loop
card of the FireFinder-XLS System, the FS-DLC device
loop card of the FS-250 System, the FC922/FV922,
FC2025/FV2025 periphery FCI2016 Board (250p)
detector circuits, and the FC2050/FV2050, FC924/FV924
FCI2017 periphery board (500p) detector circuits. Each HCP
uses one device address on the device loop.
PROGRAMMING Use the DPU Programmer/Tester to program and test the module.
The HCP may only be assigned addresses 1 to 60. It is recommended to program
the HCP devices first to ensure that enough addresses have been reserved for them.
Other devices may then be assigned to addresses in this range that were not
assigned to an HCP.
Disconnect wire at terminal 1 and 2 on TB1 before programming.
To set the HCP device address:
• Plug the programming cable of the DPU Programmer/Tester into the two-
pin programming points on the HCP. (See Figure 1 for location.)
• Set the device address for the HCP by following the instructions in the DPU
Programmer/Tester Manual, P/N 315-033260.
Each HCP can be assigned a custom message using either the Zeus Programming Tool
(XLS System), the FS-CT2 (FS-250 System), the FC2025/2050, FV2025/2050 FSX2002
Engineering Tool, or the FC922/924, FV922/924 FSX7212 Engineering Tool. Refer to
the Zeus Quick Start Manual, P/N 315-033875, or the FS-250 Programming Manual, P/
N 315-049403, as applicable.
PROGRAMMING
POINTS
DEVICE ADDRESS:
D
IS
C
O
N
NE
CT
W
IRE
AT TE
RM
INAL
"1"
&
"2"
SIEMENS INDUSTRY, INC.
C
A
U
T
IO
N
O
N
T
B
1
B
E
F
O
R
E
P
R
O
G
R
A
M
M
IN
G
FLORHAM PARK, NJ, 07932
INSTALLATION INSTRUCTIONS
T
B
2
O
N
B
A
C
K
S
ID
E
P/N 315-034860
SIEMENS
MODEL: HCP
T
B
1
O
N
B
A
C
K
S
ID
E
6
5
4
3
2
1
1
2
3
4
5
6
Figure 1
HCP Intelligent Control Point

Siemens HCP Specifications

General

Brand	Siemens
Model	HCP
Category	Control Unit
Language	English