en Appliance door
34
Fitting and removing the glass panels
To facilitate cleaning, you can remove the glass panels
from the appliance door. If required, for example if the
appliance is installed higher up, you can remove the
entire door and lay it on a flat surface.
Locking the appliance door
1. Open the appliance door fully.
2. Open the two locking levers on the left and right
(fig. !).
3. Close the appliance door as far as it goes (fig. ").
Removing panels
1. Press on the left- and right-hand sides of the cover
(fig.°!).
2. Remove the cover (fig. ").
3. Lift out the inner panel (fig. #) and set it down
carefully on a flat surface.
4. Take off the seal on both sides and remove it
(fig. $).
5. Lift out the intermediate glass panel (fig. %) and set
it down carefully on a flat surface.
6. If necessary, you can remove the condensate trough
for cleaning. To do this, open the appliance door
fully (fig. &).
7. Tilt the condensate trough up and remove it (fig. ').
Clean the panels with glass cleaner and a soft cloth.
Wipe the condensate trough with a cloth and some hot
soapy water.
2
1
2
1
To Next Page
Loading...
