LOGO! Manual
A5E00067781 01
140
Removing the module
Remove the program module/card as follows:
RC–0047
Carefully insert a screwdriver into the slot at the upper end
of the program module/card and ease the program module/
card out of the shaft a little.
You can now remove the program module/card:
Inserting the program module/card
The shaft for the program module/card is chamfered at the
lower right edge. The program module/card also has a
chamfered edge. This prevents you from inserting the pro-
gram module/card the wrong way around. Insert the pro-
gram module/card into the shaft until it engages.
LOGO! Pro
ram Modules
To Next Page
Loading...
