Siemens LOGO! 8 - Enabling and Configuring Web Server

3 Installation and Commissioning
Frei verwendbar House Control with Master-Slave - LOGO! Set 9
Entry ID: 64143308, V2.2, 09/2018
23
© Siemens AG
2018 All rights reserved
3.5 Setting web server access
To be able to operate the application example using the integrated LOGO! web
server, the web server must first be enabled using the LOGO! Soft Comfort V8
menu. Start LOGO! Soft Comfort V8 and make the following settings:
Table 3-4
No.
Action/response
LOGO! Soft Comfort V8
1.
In the menu, navigate to
"Tools > Transfer > Access
Control”.
2.
Select the interface for your
connection to LOGO! and
enter the IP address of your
LOGO!. Click "Test” in order
to check whether the
connection has been
established successfully. If
the connection is successful
click "OK”.
Note:
If you are asked for a
password, enter "LOGO”
(preset LOGO! password).
3.
Click "Yes” to set the LOGO!
to STOP.