Siemens LOGO! 8 - Master-Slave LOGO! Communication

2 Solution
Frei verwendbar House Control with Master-Slave - LOGO! Set 9
Entry ID: 64143308, V2.2, 09/2018
15
© Siemens AG
2018 All rights reserved
2.4 Reading inputs from a slave LOGO! and controlling
outputs of a slave LOGO!
When the master/slave mode is set, you can read inputs from a slave LOGO! and
control outputs of a slave LOGO!.
The table below describes the LOGO! program settings for this:
Table 2-13
No.
Action/response
LOGO! Soft Comfort V8
1.
Start LOGO! Soft Comfort V8.
2.
Click in the Mode bar on "Network Project” to
open the project mode.
3.
Click on "Add new device”. The subsequent
window enables you to add devices you want
to use to the network (in this example a
master and a slave LOGO!).
4.
The "Network view” gives you an overview of
the devices used in your network (in this case
a master and a slave LOGO!).
5.
Now, go to the diagram in the "diagram
editor”.