Frei verwendbar House Control with Master-Slave - LOGO! Set 9
Entry ID: 64143308, V2.2, 09/2018
© Siemens AG
2018 All rights reserved
If you want to use the input of the slave
LOGO! in the program, select a digital
"Network input” from the "Instructions tree”
and add it to your switching program.
Then double click on the digital "Network
input” in the program to open its block
properties.
Perform the following steps in the block
properties:
1. Select the "Remote device” item.
2. The slave LOGO! that you have already
added to the network view before now
automatically appears under "Device/IP
address”. Select it.
To Next Page
Loading...
