Siemens M1 - AT+CMGW - Write Message to Memory; AT+CMGD - Delete Message; AT+CNMI - New Message Indications

59
GSM M1 Module, English: A24859-N4000-A100-1-7677
gsm-m1-e.fm
Technical reference section
6.3.96
This command allows you to store a short message in the memory <mem2>. The
memory location is returned in <index>.
Action command syntax
This command allows you to delete a short message from <mem1> at the location <in-
dex>.
Action command syntax
This command allows you to determine how the TE will be notified when a short mes-
sage is received from the network, when the TE is activated.
Parameter Command Syntax
<ds> Sets result code indication routing for SMS-STATUS-REPORTS.
<bfr> Defines the handling method for buffered result codes when
<mode> 1,2 or 3 is enabled.
AT+CMGW - Write message to memory
Command Possible response(s)
If PDU mode (+CMGF=0):
+CMGW= <length> [,<stat>]<CR>PDU
is given <ctrl-Z/ESC>
+CMGW: <index>,
+CMS
ERROR : <err>
+CMGW=?
AT+CMGD - Delete message
Command Possible response(s)
+CMGD= <index> +CMS
ERROR : <err>
+CMGD=?
AT+CNMI - New message indications
Command Possible response(s)
+CNMI=[<mode>[,<mt>[,<bm>[,<ds>
[,<bfr>]]]]]
+CMS
ERROR : <err>
+CNMI? +CNMI: <mode>,<bm>,<ds>, <bfr>
+CNMI=? +CNMI: (list of supported <mode>s),
(list of supported <mt>s) , (list of sup-
ported <bm>s) , (list of supported
<ds>s) , (list of supported <bfr>s)