Siemens M65 - Direct Call

right page (47) of M65 SUG X-Cite en, A31008-H7150-A1-4-7619 (09.08.2005, 15:31)
©
Siemens AG 2003, C:\Siemens\DTP-Satz\Produkte\SAR_Update_050805\m65_retail\en\M65K_Setup.fm
47Setup
VAR Language: en; VAR issue date: 041104
Security
C¢T¢Security
¢Select function.
Auto key lock
The keypad is locked automatically if
no key has been pressed for one
minute in standby mode. This pre-
vents the phone from being used
accidentally. However, you can still
be called and you can still make an
emergency call.
Direct call
Only one phone number can be
dialled. The required phone code
(4 to 8-digits) is set by you and
entered at the first security setting.
#
To switch off, hold down,
then enter the phone
code.
Only ‚ b
Restrict calls to SIM-protected num-
bers in the Phonebook.
This SIM only b
Your phone is prevented from being
used with a different SIM card.
Codes
For description see p. 14:
PIN control, Change PIN, Change PIN2,
Chg.phonecode
Barrings b
Network barring restricts the use of
your SIM card.
All outgoing
All outgoing calls except emergency
numbers are barred.
Outgoing intl. (outgoing international)
Only national calls can be made.
Out.int.x.home (outgoing international
without home country)
No international calls, only calls to
the home country.
All incoming
The phone is barred for all incoming
calls.
Additional information
Block/unblock in standby mode. In each
case:
#
Hold down
.