7ML19981FB05 MultiRanger 100/200 – INSTRUCTION MANUAL Page 15
mmmmm
Wiring
Wiring
Please note:
• Verify that all system components are installed in accordance with instructions.
• Connect all cable shields to the MultiRanger Shield Terminals. Avoid differential
ground potentials by not connecting cable shields to ground (earth) anywhere.
• Keep exposed conductors on shielded cables as short as possible to reduce noise
on the line caused by stray transmissions and noise pickup.
Siemens Milltronics
Transducer(s)
Laptop running
Dolphin Plus
Customer Alarm,
Pump, or Control
Device
Siemens Milltronics
TS-3 Temperature
Sensor
Customer Device,
digital output
Customer Device,
analog output
Customer Network or
Modem
SmartLinx Card
Display, PLC, Chart
recorder, or other
Control Device
MultiRanger
To Next Page
Loading...
