3 - 1
Siemens-Elema AB SPB7-230.812.06 Page 1 of 2 Opdima®
Solna, Sweden Rev. 01 03.03 SPS-UD Installation
ASW 3.1 3
Adjusting resolution 3
1. Log in as Service.
2. In Mode Selection window, click on Service.
3. In Service window, click on Advanced Service.
4. Select 3 (Software Upgrade) from the SERVICES menu and press enter.
5. Select 6 (Miscellaneous) from the SOFTWARE UPGRADE menu and press enter.
6. Select 5 (Select monitor type) from the MISCELLANEOUS menu and press enter.
7. Enter Refresh rate: 85
8. Select Apply and press enter.
9. A message that the refresh rate has been set appears. Close the Advanced
Service window.
10. Close the MISCELLANEOUS menu.
11. Close the SOFTWARE UPGRADE menu.
12. Close the SERVICES menu.
13. Close the Service window.
14. Log out.
Adjusting image geometry 3
1. Log in as Service.
2. Maximize the Mode Selection window by clicking on the upper right corner.
3. Press the Menu button on the right side of the monitor. A menu for screen settings
is opened.
4. Select Auto (use the menu button to move in the menu).
5. Open the Auto sub menu by pressing the button with an "up" arrow on the right
side of the monitor.
6. Select Auto choose source (use the menu button to move in the menu) and then
press the "up" arrow button to activate.
7. Check that the size of the Mode Selection window corresponds with the active
area of the screen.
8. Press the Menu button on the right side of the monitor to open the menu for screen
settings.
9. Select Others (use the menu button to move in the menu) and then press the "up"
arrow button to activate.
10. Select Status (use the menu button to move in the menu) and then press the "up"
arrow button to activate.
To Next Page
Loading...
