Siemens MAMMOMAT Novation DR

Other manuals for Siemens MAMMOMAT Novation DR

Installation And Startup44 pages

Parts Replacement64 pages

Installation Manual104 pages

Questions and Answers:

D
donna05Aug 11, 2025
Why is there a line parallel to the short axis on my Siemens MAMMOMAT Novation DR?
- M
  mosleysaraAug 11, 2025
  If you observe a line parallel to the short axis on your Siemens Medical Equipment, it could be due to several reasons related to seam correction and detector calibration. Specifically, the seam correction algorithm might not be turned on or the wrong algorithm might be selected. Another cause could be that the detector gain isn't calibrated properly, or the seam (lines 1535 and 1536) needs mapping. If the issue stems from source lines, it might be due to improper detector calibration or the line needing mapping. To address this: * Perform the detector calibration procedure. * Perform the bad pixel correction.
S
smithmichaelAug 17, 2025
How to fix a line parallel to the long axis on Siemens MAMMOMAT Novation DR Medical Equipment?
- S
  Sara RushAug 17, 2025
  If you see a line parallel to the long axis on your Siemens Medical Equipment, it could be due to a line ending at the seam or a partially defective line (gate lines). It might also be caused by the detector not being calibrated properly or the line needing to be mapped out. To resolve this: * Perform the detector calibration procedure. * Perform the bad pixel correction.
G
gsmithAug 22, 2025
What to do if Siemens MAMMOMAT Novation DR shows a line parallel to the short axis?
- B
  Brenda FosterAug 23, 2025
  If you observe a line parallel to the short axis on your Siemens Medical Equipment, it could be due to several reasons. First, the seam correction algorithm might not be turned on, or the wrong algorithm might be selected. Another potential cause is that the detector gain hasn't been calibrated properly. Also the seam might need to be mapped out. To address these issues, perform the detector calibration procedure and perform the bad pixel correction.
W
Walter MyersAug 29, 2025
What to do if Siemens MAMMOMAT Novation DR shows a line parallel to the long axis?
- A
  Alejandro McguireAug 29, 2025
  If your Siemens Medical Equipment displays a line parallel to the long axis, it could be caused by a line ending at the seam, a partially defective line (gate lines), or the detector not being calibrated correctly. To resolve this, perform the detector calibration procedure and perform the bad pixel correction.
E
Erica WagnerSep 4, 2025
Why does Siemens MAMMOMAT Novation DR Medical Equipment show a line running through the seam?
- J
  Jessica MyersSep 4, 2025
  A line running through the seam on your Siemens Medical Equipment might indicate a read-out problem, possibly due to the HV setting time being too short, or it could be a hard copy device or processor artifact. Follow applicable problem solving to resolve this issue.