To Next PageTo Next Page
Need help?Do you have a question about the Siemens MAMMOMAT 1000 and is the answer not in the manual?
General| Exposure Control | Automatic Exposure Control (AEC) |
|---|---|
| X-ray Generator | High Frequency Generator |
| Tube Voltage | 24 - 35 kV |
| Focal Spot Size | 0.3 mm / 0.1 mm |
| Target Material | Molybdenum |
| Anode Material | Molybdenum |
| Filter Material | Molybdenum or Rhodium |
| Compression | Automatic and Manual |
| Mammography Modes | Standard |
| Power Supply | 220-240 V, 50/60 Hz |
| Image Receptor | Film-Screen |
| Detector Type | Film-screen |
| Image Receptor Size | 18 cm x 24 cm, 24 cm x 30 cm |
| Dimensions | Varies depending on configuration |
| Weight | Varies depending on configuration |
| Type | Analog Mammography System |
| Image Processing | N/A (Analog System) |
Covers initial requirements, serial number considerations, and general setup.
Details the requirement for trained personnel for setup, service, and maintenance.
Explains the meaning of DANGER, WARNING, CAUTION, NOTICE, and NOTE symbols.
Lists necessary documents, CD-ROMs, meters, appliances, and tools for installation.
Covers initial start-up procedures and regulatory compliance for X-ray application.
Provides critical safety guidelines for handling the sensitive CCD camera to prevent damage.
Outlines essential safety steps before performing interventions, including power disconnection and software shutdown.
Details precautions for safely handling sensitive electronic boards using ESD equipment.
Lists all components included in the standard and optional equipment delivery.
Provides guidance on how to unpack the workstation, biopsy controller, and CCD camera.
Describes backing up installation parameters before starting the main installation process.
Presents a diagram illustrating the main components of the MAMMOMAT system.
Details the procedure for removing front and rear covers from the MAMMOMAT stand.
Explains the steps for attaching the holders for the biopsy controller to the stand's rear cover.
Covers required software updates and board replacements for specific MAMMOMAT serial numbers.
Details installing the isolation board D707 and replacing system software.
Guides on restoring system parameters after software changes.
Illustrates and describes the connection and routing of various system cables.
Details cable connections to the generator, biopsy unit, and CCD camera.
Covers preparing the workstation table and connecting various workstation components.
Details connecting the workstation to a network and installing an optional printer.
Describes managing cables and performing final functional tests on the workstation table.
Covers initial system startup, workstation login, and MO unit operations.
Details software reinstallation, mounting of covers, and filling out documentation.
Explains performing DHHS maintenance and related measurement certificates.
