Opdimar Register 3 SPB7-230.033.12 Page 6 of 26 Siemens-Elema AB
Installation Rev. 01 09.02 SPS-UD Solna, Sweden
5 - 6 Installation
Modification of MAMMOMAT stand 5
MAMMOMAT with serial number lower than 5200 must be updated with new software.
1. Replace the existing software on board D801 with the V2.2 (or higher) software.
Modification of MAMMOMAT generator 5
Replacing board D702 5
MAMMOMAT with serial number lower than 3242 must be updated with a new board
D702.
1. Pry loose the plastic strips (1/Fig. 6), using a screwdriver or similar tool.
2. Remove the sixteen screws (2/Fig. 6) and remove the front cover (3/Fig. 6).
3. Remove the board D702 in Fig. 7 from the generator.
4. Install software V2.2 (or higher) on the new board D702.
5. Install the new board D702 Fig. 7 in the generator.
If upgrading from a version lower than V1.5, the AEC have to be
upgraded, see Update Instruction, UI 001/96.
If upgrading from a version lower than V1.5, the AEC have to be
upgraded, see Update Instruction, UI 001/96.
NOTE
OPD00153
3
1
2
Fig. 6 Removal of generator front cover
NOTE
To Next Page
Loading...
