Siemens MAMMOMAT 1000 - Removal of MAMMOMAT Stand Covers; MAMMOMAT Stand with Separate Rear Side Covers; Left Rear Side Cover; Right Rear Side Cover

Opdimar Register 3 SPB7-230.033.12 Page 2 of 26 Siemens-Elema AB
Installation Rev. 01 09.02 SPS-UD Solna, Sweden
5 - 2 Installation
Removal of MAMMOMAT stand covers 5
MAMMOMAT stand with separate rear side covers 5
Left rear side cover 5
1. Remove the screw (5/Fig. 2) at the top of the stand.
2. Pry loose the plastic strip (2/Fig. 2) using a screwdriver or similar tool.
3. Remove the screws (3/Fig. 2) and remove the cover (6/Fig. 2).
Right rear side cover 5
1. Remove the screw (1/Fig. 2), proceed as for the left side cover and remove the
right side cover (4/Fig. 2).
Middle rear cover 5
1. Remove the two screws (7/Fig. 2) at the top of the stand.
2. Remove the cover (8/Fig. 2) by lifting it up.
High voltage!
Life-threatening electric shock hazard exists.
Switch off the power to the system with the main circuit breaker.
WARNING
9
7
4
8
6
3
2
OPD00150
1
5
Fig. 2 Removal of covers