Opdimar Register 3 SPB7-230.033.12 Page 14 of 26 Siemens-Elema AB
Installation Rev. 01 09.02 SPS-UD Solna, Sweden
5 - 14 Installation
Cables to CCD camera 5
The CCD camera including cable with connectors marked X201 and X202 is connected to
the biopsy controller.
1. Connect the cable to X201 and X202 on the biopsy controller, see Fig. 11.
2. Remove the screws (1/Fig. 14) and remove the cover (2/Fig. 14) of the object table
arm.
Sensitive electronic equipment!
Risk of damaging the camera.
Do not touch the pins in the contacts of the CCD camera.
OPD00475
1 (BN)
2 (BU)
3 (GNYE)
X885
X881
Protective earth cable
Fig. 13 Connection of mains cable, protective earth cable and X885, serial number lower than 3000
CAUTION
OPD00161
1 2
Fig. 14 Object table arm before installation
To Next Page
Loading...
