Siemens MAMMOMAT 1000 - Page 29

Installation 5 - 15
Siemens-Elema AB Register 3 SPB7-230.033.12 Page 15 of 26 Opdimar
Solna, Sweden Rev. 01 09.02 SPS-UD Installation
1. Install a new thread (1/Fig. 15).
2. Install the holder (1/Fig. 16) with the pull relief device, using included Allen screws
(2/Fig. 16).
OPD00162
1
Fig. 15 Installation of thread
OPD00163
21
Fig. 16 Object table arm after installation