Opdimar Register 3 SPB7-230.033.12 Page 24 of 26 Siemens-Elema AB
Installation Rev. 01 09.02 SPS-UD Solna, Sweden
5 - 24 Installation
Connecting the workstation to the network 5
The Opdima workstation can be connected to a network, partly for the use of DICOM and
also for networked printers.
1. Connect one end of the network cable (included in the delivery) to the workstation.
2. Connect the other end of the network cable to a network socket.
3. Log in with the user name “service”. The password is obtained from Siemens
Service Centre.
4. Press the Service button in the mode selection dialog, see Selection of mode in
MAMMOMAT 1000/3000/3000 Nova - Opdimar Service Instructions.
5. Press the Advanced service button in the service dialog, see Use of Advanced
service functions in MAMMOMAT 1000/3000/3000 Nova - Opdimar Service
Instructions.
6. In Advanced service configure the network parameters, see Network settings in
MAMMOMAT 1000/3000/3000 Nova - Opdimar Service Instructions.
For physical limitations of the network see Mammomat 1000/3000/3000 Nova -
Opdimar Planning Guide.
Installation of Opdima printer (option) 5
Stand alone Opdima system:
When the Opdima system is stand alone (not connected to a network) it is possible to
install a Codonics NP-1660 or NP-1600 printer to Opdimar as a stand alone printer
connected to the network connector.
The following equipment is needed:
• Codonics printer NP-1660 or NP-1600
• Crossover network cable
Proceed as follows to install the printer:
1. Connect one end of the network cable to the workstation (9/Fig. 25).
2. Connect the other end of the network cable to the printer.
3. Connect the mains cable of the printer to the wall socket marked with label,
see Fig. 24.
4. Set the printer IP address to 10.10.10.2 see the User’s Manual for the Codonics
NP-1660 or NP-1600.
It is also possible to connect a stand alone postscript printer to
the parallel or network connector of the workstation, see Use of
printer setup in MAMMOMAT 1000/3000/3000 Nova - Opdimar
Service Instructions.
The printer must be grounded to the same potential as the
MAMMOMAT.
Connect the printer power supply to the same branch circuit as
the MAMMOMAT power supply.
NOTE
CAUTION
To Next Page
Loading...
