Siemens MAMMOMAT 1000 - General; MAMMOMAT with Serial Number Lower than 2091; MAMMOMAT with Serial Number Within the Interval 2091-3241; MAMMOMAT with Serial Number Within the Interval 3242-5199

1 - 1
Siemens-Elema AB Register 3 SPB7-230.033.12 Page 1 of 4 Opdimar
Solna, Sweden Rev. 01 09.02 SPS-UD Installation
Prerequisites 1
General 1
Depending on the serial number of your MAMMOMAT, complementary measures may
have to be performed when installing Opdimar. Where necessary, the measures are
described in these instructions. The following has to be carried out with all serial numbers:
• Installation of isolation board D707 (kit part No. 63 96 704) in the generator, if not already
done in conjunction with installation of printer (option)
• The wall socket for the workstation power supply must be connected to the same branch
circuit as the MAMMOMAT power supply
• This Installation and Start-Up Instruction is valid for Opdimar systems;
- with SUN workstation part No. 64 30 453 / Ultra 10 with ASW 3.0
MAMMOMAT with serial number lower than 2091 1
The following has to be carried out:
• Exchange of printed circuit board D702 (kit part No. 64 21 288) in the generator
• Upgrade of the MAMMOMAT software (generator and stand) to V 2.2 (part No.
62 98 769, if the version to be upgraded is lower than V1.5, the AEC have to be
upgraded, see Update Instruction, UI 001/96)
• Performance of “Stereotactic biopsy attachment update” according to MAMMOMAT
3000 Installation and Setting Instructions Update Kit for Stereotactic Biopsy Attachment
RX B7-230.033.02. ..
MAMMOMAT with serial number within the interval 2091-3241 1
The following has to be carried out:
• Exchange of board D702 (kit part No. 64 21 288) in the generator
• Upgrade of the MAMMOMAT software (generator and stand) to V2.2 (part No.
62 98 769, if the version to be upgraded is lower than V1.5, the AEC have to be
upgraded, see Update Instruction, UI 001/96)
MAMMOMAT with serial number within the interval 3242-5199 1
The following has to be carried out:
• Upgrade of the MAMMOMAT software (generator and stand) to V2.2 (part No.
62 98 769, if the version to be upgraded is lower than V1.5, the AEC have to be
upgraded, see Update Instruction, UI 001/96)