Opdimar Register 3 SPB7-230.033.12 Page 2 of 4 Siemens-Elema AB
Installation Rev. 01 09.02 SPS-UD Solna, Sweden
6 - 2 Final procedures
Starting up the MAMMOMAT 6
Switch on the MAMMOMAT.
Starting up the workstation and login 6
The workstation is started according to instructions in Starting up the workstation and
login in Supplement to the Instructions for Use MAMMOMAT 3000 - Opdimar.
Use the user name “service” and the password obtained from Siemens service center
when entering the system.
To obtain optimal picture, adjust the monitor settings as follow:
Brightness: 50260
Contrast: 100
Starting up the MO unit 6
1. Insert the MO disk, type 2.3 GB MO disk
2. For switch settings, SCSI ID and termination see Ultra 10/Ultra 1 MO unit in
MAMMOMAT 1000/3000/3000 Nova - Opdimar Service Instructions.
Installation of software 6
The software is installed in the factory before delivery. If the software for any reason
needs to be reinstalled, refer to Reinstallation of software in MAMMOMAT 1000/3000/
3000 Nova - Opdimar Service Instructions.
Mounting of covers 6
Mount the covers previously removed.
Filling in of IVK list 6
Fill in the IVK list or report the IVK components to your responsible uptime service center
(USC).
HEWLETT
PACKARD
Fig. 1 Magneto-optical drive (HP)
To Next Page
Loading...
