Migration from MC35 to MC35i
PRELIMINARY
Migration from MC35 to MC35i
8 of 30 12.03.03
Table 2: General description b)
Features Parameter MC35 MC35i
Supported services 2400 bps (V.22bis)
4800 bps (V.32)
9600 bps (V.32)
14400 bps (V.34)
2400 bps (V.110)
4800 bps (V.110)
9600 bps (V.110)
14400 bps (V.110)
USSD support Supported
Connection element non-transparent mode
Data
Autobauding supported
Fax Supported classes Group 3: Class 1, Class 2
Connectivity GPRS multi-slot class 8
GPRS mobile station class B
Data downlink transfer max. 85.6 kbps
Data uplink transfer max. 21.4 kbps
Coding scheme CS-1, CS-2, CS-3 and CS-4
PAP (Password
Authentication Protocol)
Supported
Challenge Handshake
Authentication Protocol
Supported
GPRS
Packet Switched Broadcast
Control Channel (PBCCH)
Supported
RF interface: GSC antenna connector only
Power: 3 additional power pads available
External interfaces
Application interface: 40-pin ZIF connector
Baud rate: Fixed range
(300bps...115kbps)
Autobauding
(1.2kbps...115kbps)
Fixed range (300bps...230kbps)
Autobauding (1.2kbps...230kbps)
Local character framing: 8N1- fixed
Multiplex mode: Supported
Serial interface
Flow control: RTS/CTS hardware handshake and software XON/XOFF flow control.
Software update Via serial interface and SIM interface
3.2 Certification and standards
Both MC35 and MC35i comply with the same directives and standards. However,
please note that a new R&TTE approval of the host application is required after
migration from MC35 to MC35i.
For further information please consult the HW manual for M35 and MC35i.
To Next Page
Loading...
Need help?
General
