6
To meet these requirements, two wire ducts are
mounted along the sides of the rack assembly, as
shown in Figure 8. Remove the wire duct cover,
route all non-power limited wiring through the
ducts, then snap the cover back in place.
Refer to the Installation and Power Limited Wiring
Instructions for the MME-3 Backbox, P/N 315-
094883, for further information on power and
non-power limited wiring.
NOTE: If power-limited wiring is not used within a
rack mount system, then the following
guidelines do not apply. In that case, be
sure to follow standard wiring practices.
4ELBAT
TIKKR-SELBAC
)440398-005N/P(
ELBAC
EPYT
FOEPYT
METSYS
SECALPER
SDNETXERO
STCENNOC
SELUDOM
ELBAC
HTGNEL
nobbiRrotcudnoC41VLXMsecalpeR1P,1-MCA
ot
3P,1-MMT
"42
nobbiRrotcudnoC51VLXMsecalpeR4P,1-MCA
ot
P,1-NNA
1
"42
VLXMsecalpeR
8P,2-BMM
ot
P,1-MCA5
nobbiRrotcudnoC51ro"04
LXMsecalpeR
8P,2-BMM
ot
P,1-NNA
1
yrettaBeriW2VLXM/LXMsecalpeR2P,2/1-BMM
ot
yrettaB
"06
elbaCeriW9VLXMsdnetxE1-MMM
ot
7P,1-MCA
"6
To Next Page
Loading...
