7.2 Configuring IP settings via NW8202
This configuration must be performed before the NK8000 can be configured at the
client’s site. This procedure details how to send the IP configuration information;
that is, the IP address, Subnet mask, and Default address to the NK8000 via the
NW8202 Tool.
Note: This configuration procedure can be performed prior to shipping the
NK8000 to the client, or at a later time at the client’s site.
1. Set the Service PC IP address to 192.168.9.x (for example 192.168.9.254) and
the subnet mask to 255.255.255.0.
Note: Make note of the current IP address before replacing it with the new one.
2. Remove the cover of the NK82xx to be configured (NK822x: press the 4 white
tabs to the rear of the left and right sides of the unit and lift gently).
3. Open the NW8202 application by selecting NW8202.exe located in
<InstallationDir>\Utilities\NW8202 folder.
Note: On Windows 7/8 it might be needed to launch NW8202 with "Run as
administrator" (depending on your system security settings).
4. Select the Firmware Version NK823x.
Note: If NK823x is not indicated with a specific option, use latest NK822x.
5. Select the Download Mode: FTP (default) or Secure Download (encrypted data
transmission that makes use of TCP port 20500).
– If FTP is selected, select the FTP Mode: Active (default) or Passive
(needed if a firewall is active in the PC).
6. Enter IP address, Subnet mask, and Default gateway in the corresponding
fields.
NW8202 IP configuration download tool
To Next Page
Loading...
