Siemens NK8232

Maintenance and diagnostics
The NW8204 maintenance and diagnostic tool
9
69
Building Technologies
A6V10062437_a_en
Fire Safety & Security Products 30.06.2013
8 Download/Upload
progress status
Transferred Bytes, Percent, and Byte/Sec rate.
Note: If you do not close the connection, you will automatically be timed out in five
minutes.
9.4.2 File commands
These commands are meant for remote technical maintenance and diagnostic of the
NK8000 units. The commands apply to the file selection active in the list on the left
hand side of the screen.
Download file
Transfer the selected file from the NK8000 .
Upload file
Transfer the selected file to the NK8000 (to upload diagnostic files see Uploading
diagn
ostic files [➙ 72]).
Delete/renam
e file
Delete or Rename the selected file in the NK8000.
Refresh
Update the file list.
Properties
Display the detailed properties if the selected file.
Download Reset NK
Download a file that forces the NK8000 to perform a software reset.
Edit Configuration File
Edit/View the INI file containing the NK8000 configuration.
Edit Diagno.log
Edit/View the diagnostic file (see Uploading diagnostic files [➙ 72]).
Edi
t EEprom.log Event.log
Edit/View the diagnostic file (see Uploading diagnostic files [➙ 72]).
9.4.3 Diagnostic functions
Reset NK
Allows you to reset an NK8000 from a remote location.
Note: This function is only available when logged in as user “admin”.
Save EEProm on file
Stores the content of the EEProm in the file EEProm.LOG on the NK8000 flash disk.
Set System Time
Sets the RTC (Real Time Clock) of NK8000 to the PC system time.