Siemens NK8232

Maintenance and diagnostics
9
The NW8204 diagnostic tool
67
Building Technologies
A6V10062437_a_en
CPS Fire Safety
30.01.2019
Read all subsystems configured. Displays a dialog box with a list of configured
subsystems organized by name, number, and creation date.
Read Kernel Version
Read the version of the Linux kernel installed on NK823x .
Read NK Version
Reads the version of the installed NK82xx firmware (NK82xx.EXE).
Read NK Date Time
Read current settings of date and time from the NK8000 RTC.
Read CPU ID
Reads the CPU ID from the DIMM-PC module on NK822x.
Read Product ID
Reads the Product ID from the NK82xx. The Product ID is used to distinguish
between NK8222, NK8223, and NK8225.
Read HW Conf. ID
Read the HW Configuration ID from the unit. The HW Conf. ID is used to check the
HW Configuration from a remote location:
⚫ Serial:
– NH8002 (NK822x) serial port add-on board installed.
– NKA8001-A1 or NKA8001-A2 (NK823x) serial port add-on board installed.
⚫ LON: NH8010 PC-104 LON add-on board installed (NK822x).
⚫ Serial + LON: NH8002 + NH8010 installed (NK822x).
Read Memory
Display the amount of RAM (in bytes) available on the NK8000.
Note: This functionality is not available in the NK8000 Web Server NS8210 tool.
Read Connected IP
Read the IP address of the last host PC that was connected to the selected port.
Note: This functionality is not available in the NK8000 Web Server NS8210 tool.
Click this button to display the Port Number dialog box:
Port number request
Possible port numbers are 3001, 3002, 3003, 3004, and 4000 (CMSDL/IP) or
47808 (BACnet).
Click OK to check the port number. At that point, the associated field shows the
type of information found (for example, Last IP connected) and you can use the
field arrow controls to display the current IP address.
Note: If the IP address is ‘0.0.0.0’, no PC was connected to that port.
Read HW version