16-3
Manual OP5, OP15
( ) J31069-D0840-U001-A2-7618
This key combination deletes the configuration from its memory. The OP
then switches to Download mode with the message ”Ready for
Transfer”.
4. Start the download operation to the OP on the PC or PU. The OP checks
the link to the PC or PU. If a link is not available or if it is not functioning
properly, the OP issues a corresponding error message. If the link is in
order, downloading of the configuration from the PC or PU is initiated to
the OP. In doing so, the present configuration on the OP is overwritten by
the new one.
Once the configuration has been successfully downloaded, the OP runs up
again and displays the standby message.
Any fault occurring during commissioning or in operation is normally dis-
played by means of an error message on the display of the OP.
You will find an overview of the most important system messages together
with notes on troubleshooting in an appendix to this manual.
Fault diagnosis
Commissioning
To Next Page
Loading...
