17-7
Manual OP5, OP15
( ) J31069-D0840-U001-A2-7618
The figure below shows the location of the connection and setting elements
on the back of the floppy disk station.
+–
1
COM1, 25-way, sub D socket, connection to the OP
2
3
4
5
COM2, 15-way, sub D socket, connection of the printer for
loop through operation
Connection for the power supply. 24 V DC (minimum of 18 V/max-
imum of 34 V) is required for the power supply. Connection is per-
formed with Phoenix connection terminals protected against pole
reversal.
Grounding terminal
Fine-wire fuse
DIP switch, factory setting: both OFF. (Do not change this
setting.)
6
2 1 6 3 5
4
Figure 17-4 Connection and setting elements on the floppy disk station
Connection and
setting elements
Device Description
To Next Page
Loading...
