Siemens OP15 - Page 135

B-1
Manual OP5, OP15
( ) J31069-D0840-U001-A2-7618
System Messages
System messages on the OP can be placed in different categories.
Information on the category to which a system message belongs is contained
in the message number:
 Message text
Message number
0 Driver error
1 Start-up message
2 Warning
3 Note
4 Operating error
5 Other message
6 Configuration error
7 Internal error
The message category gives you a rough idea of the cause of a system message.
A few important system messages are shown below together with their causes
and the action that has to be taken to remedy the errors.
Self-explanatory system messages are not included.
Note
Messages are displayed in English until configuration data have been down-
loaded to the OP.
Proceed as follows for all system messages that relate to ”internal errors”:
a) Switch off the OP, put the PLC in STOP mode and restart the OP and the
PLC.
b) Put the OP in Download mode during start-up (refer to section 16.1),
download the configuration again and restart the OP and the PLC.
c) If the error continues to occur, please contact the nearest Siemens branch
office. Report the number of the error that has occurred and any variable
that may be included in the message.
Message number
Procedure in case
of ”internal errors”
B