E-3
Manual OP5, OP15
( ) J31069-D0840-U001-A2-7618
E.5 Shipping ESD Assemblies
As a matter of policy, assemblies and devices should be stored and shipped
only in conductive packing – for example, metallized plastic boxes, tin cans.
Should packing not be conductive, assemblies must be conductively wrapped
before they are packed. You can use, for example, conductive foam rubber,
ESD bags, domestic aluminum foil and paper (under no circumstances should
you use plastic bags or foils).
With assemblies containing fitted batteries, make sure that the conductive
packing does not come into contact with or short-circuit battery connections;
if necessary, cover battery connections beforehand with insulating tape or
insulating material.
Conductive
packing
Protecting/
covering battery
connections
ESD Guidelines
To Next Page
Loading...
