Step by Step
Using Other Functions
78
Using System Functions from the Outside
(DISA: Direct Inward System Access)
If this function has been configured (contact your serv-
ice personnel), you can set up external outgoing calls
from outside the system, just like an internal user. You
can also activate and deactivate the following functions
in your system:
• Reset services and functions,
code: #0 Æ Page 76
• Call forwarding, code:
*
1/#1 Æ Page 20
• Lock and unlock all phones,
code:
*
66/#66 Æ Page 67
•Save PIN,
code:
*
93 Æ Page 69
• Send a message,
code:
*
68/#68 Æ Page 70
• Leave an advisory message,
code:
*
69/#69 Æ Page 72
•Group ringing, code:
*
81/#81 Æ Page 84
• Group call, code:
*
85/#85 Æ Page 84
• Suppress caller ID,
code:
*
86/#86 Æ Page 65
• Waiting tone, code:
*
87/#87 Æ Page 45
• Open door, code:
*
61 Æ Page 30
• Door opener on/off, code:
*
89/#89 Æ Page 30
• Control relay, code:
*
90/#90 Æ Page 82
• Do not disturb, code:
*
97/#97 Æ Page 64
• Ringer cutoff function, code:
*
98/#98 Æ Page 64
• Speed-dialing, code:
*
7 Æ Page 35
• Associated service, code:
*
83 Æ Page 77
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o Set up a call to the system. Enter the station number
(contact your service personnel).
o Wait for a continuous tone (if necessary switch the tel-
ephone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
r Enter the code (necessary only if programmed in the
system).
To Next Page