Administration Scenarios
104
Checking Handset Functionalities
• Check whether the plugs at the two ends of the handset cable are
inserted correctly (handset engaged)
Page 13.
• Carry out an Audio Loop Test.
– More information on „Audio Loop Test“ Page 70.
– Page 27
• Ensure that the handset microphone is not switched off.
– For more information, see the operating instructions for the
optiPoint
410/420.
Startup Not Successful
Check whether one or more of the mentioned questions are valid for your
configuration:
Is the optiPoint 410/420 being operated in a VLAN?
• Enter the VLAN ID manually, or, if a DHCP server is being used, set
the „VLAN Method“ Page 93 to "DHCP", so that the VLAN ID
transferred from the DHCP server is used.
– More information on „Default VLAN ID“ Page 73.
Page 23 Page 63
Is the optiPoint 410/420 being operated behind a Gateway?
• Enter the IP Address of the gateway in Default Route.
Page 23 Page 62
Checking the LAN Connection
• Check whether the plugs at the two ends of the LAN cable are
correctly inserted (handset engaged)
Page 13.
• Check the connection with the help of the PING test.
– More information on „PING Test“ Page 85.
Page 34 Page 59
Establishing the Software Version
You can determine the version of the software that is running the
optiPoint
410/420, for example during a pending software update.
Page 51
To Next Page
Loading...
