Siemens Optipoint 420 - Page 76

Alphabetical Reference
76
• The password must match the  FTP User Name.
• Valid values: Alphanumeric
• Minimum length: 1 character (for more information, see  Password
Functions)
• Maximum length: 24 characters
• Default password: 123abc
 Page 60
FTP Server Address
• Enter the  IP Address of the  FTP server for executing up- und
downloads of files from or to the optiPoint 410/420.
• Default value  Page 109.
 Page 60
FTP Settings
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
• Displays the location of the download file via the corresponding  FTP
server.
• The following servers are available:
– Use Main FTP Settings
– Use  LDAP FTP Settings
– Use  ENB FTP Settings
 Page 60
FTP User Name
• Enter the name defined in the  FTP server as a user for accessing
this server.
• The name must match the  FTP Password.
• Valid values: 1 ... 24 characters
• Default name  Page 109.
 Page 60
Fully Qualified Subscriber Number
• Enter your full E.164 subscriber number here (example:
498972212345).
 Page 27  Page 65
G722 Codec
• Only required if the  Codec "High quality preferred" is used.
• Compression  G.722 with best quality voice transmission.
• This compression procedure is only possible between optiPoint
Workpoints.
 Page 58
Gateway Address
• Enter the  IP Address of the  PBX on which the optiPoint 410/420
is operated.
 Page 65