Alphabetical Reference
93
VLAN Method
• Can only be defined if Layer 2 support is activated ( QoS L2/L3).
• You can specify here from where the Default VLAN ID is to be
fetched when using VLANs.
Page 23 Page 18 Page 62
WAP Connection Type
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
• Choose the protocol to be used for transferring data for WAP
applications (
HTTP or WSP).
Page 56
WAP Favourites
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
• Select your WAP favourites from the list box. If no entries are
available, the list entry <empty> is displayed. For entering favourites,
see
WAP Title.
Page 57
WAP Password
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
• Enter a password for WAP gateway access.
Page 56
WAP User Name
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
• Enter the user name for WAP gateway access.
Page 56
WAP Gateway Address
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
•If a WAP server is being used, enter the IP Address of this server
here.
• Default address Page 109.
Page 56
Manual The ID entered under Default VLAN ID is used.
DHCP When using a DHCP server, the ID supplied by
this server is used.
To Next Page
Loading...
