Siemens POS8.4420/109 - Page 69

Appendix
Object list
10
A6V11471220_en--_e
69 | 70
TempDHWS
etpUserLock
ed
16
0
1
B1 / DPT_Bool
R/
W
W.in
d
TempDHWSetpUserL
ocked refers to the
proprietary input
process signal of AB
UDHWSET to lock or
enable the manual
adjustment of
TempDHWSetpUser
on the Room Unit.
TempDHWS
etpUserMin
16
1
1
V16Z8 /
DPT_TempHV
ACAbs_Z
R/
W
----
TempDHWSetpUserMi
n refers to the
configuration property
of AB UDHWSET to
define the static outer
lower limit to edit the
setpoint
TempDHWSetpUser
•
TempDHWSetpUserMi
n may be used to
initialize
TempDHWSetpUser
•
TempDHWSetpUserMi
n shall be used to
initialize
TempDHWSetpUserMi
nIN
=> [T022.S040-
3D015.070]
TempDHWSetpUserEf
f
=> [T022.S040-
3D015.080]
TempDHWSetpUserMi
nIN
TempDHWS
etpUserMax
16
2
1
V16Z8 /
DPT_TempHV
ACAbs_Z
R/
W
----
TempDHWSetpUserM
ax refers to the
configuration property
of AB UDHWSET to
define the static outer
upper limit to edit the
setpoint
TempDHWSetpUser
•
TempDHWSetpUserM
ax shall be used to
initialize
TempDHWSetpUserM
axIN
=> [T022.S040-
3D015.090]
TempDHWSetpUserM
axIN
DHWZone_C
ontroller
10
1
1
U8Z8
/DPT_UcountV
alue8_Z
R/
W
----
DHWZone refers to
the KNX standardized
configuration property
to define the number
of the DHW zone to
connect ABI DHWSM
with ABs USHWSET
and UHD.
• Supported Z8-States:
OutOfService
• Supported-Z8-
Commands:
NormalWrite, SetOSV
& ResetOSV
• Default value = 1
=> KNX Standard,
chapter 7/11/3, clause
2.2.4.14 Parameter:
DHWZone_Controller
=> [T022.S037-
2I010.015] Attaching
ABI DHWSM to the
BA-Model
=> [T022.S037-
2I020.010] Attaching
ABI DHWSM to the
BA-Model