70/221
Siemens Switzerland Ltd User manual RVS61.843 CE1U2355en_02
HVAC Products 5 Handling 23. November 2007
5.2.2 Programming
A long press on the occupancy button (> 3 seconds) enables the service level to be
accessed. When the parameter is selected, the current value blinks. The setting knob is
used to adjust the value. The next setting can be selected by a short press on the
occupancy button.
Indicatio
n
Function
ru = 1
The room unit is addressed as room unit 1 (default setting)
ru = 2 The room unit is addressed as room unit 2
ru = 3 The room unit is addressed as room unit 3
P1 = 1
Automatic storage: (default setting)
A setpoint readjustment made with the knob is adopted either by pressing
the operating mode button or without any further confirmation (timeout).
P1 = 2
Storage with confirmation:
A setpoint readjustment made with the knob is adopted only after pressing
the operating mode button.
P2 = 0
OFF: All operating elements are enabled (default setting)
P2 = 1
ON: The following operating elements are locked:
• Operating mode changeover heating circuit
• Readjustment of Comfort setpoint
• Changeover of operating level (occupancy button)
If operation lock is active and one of the locked buttons is pressed, OFF is displayed for
3 seconds.
The operation lock does not prevent the service level from being accessed.
Configuration
Settings
Used as
Direct adjustment
Operation lock
To Next Page
Loading...
Need help?
General
