Siemens RUGGEDCOM RSG2100 User Manual

Certification
6.1.2CSA/Sira
The device is marked with a CSA symbol that indicates compliance with both Canadi-
an and U.S. requirements.
C US
It is specifically approved for use in hazardous locations defined as:
• Class I, Division 2, Groups A, B, C, D T4
• Ex nA nC IIC T4 Gc
• Class I, Zone 2, AEx nA nC IIC T4 Gc
6.1.2 CSA/Sira
This device meets the requirements of the following CSA/Sira standards and is ap-
proved for use in hazardous locations under certificates Sira 16ATEX4088X and IECEx
CSA 16.0021X:
• 2014/34/EU (ATEX)
ATEX – Directive of the European Parliament and the Council of 26 February
2014 on the Approximation of the Laws of the Member States Concerning Equip-
ment and Protective Systems Intended for Use in Potentially Explosive Atmos-
pheres
• IEC 60079-0, Edition 6.0 (2011)/EN 60079-0:2012
Explosive Atmospheres – Part 0: Equipment – General Requirements
• IEC 60079-15, Edition 4.0 (2010)/EN 60079-15:2010
Explosive Atmospheres – Part 15: Equipment Protection by Type of Protection N
The device is marked with an ATEX marking.
II 3 G
Ex nA nC IIC T4 Gc
Note
For the maximum ambient temperature, refer to the hazardous location label affixed
to the device.
6.1.3 European Union (EU)
This device is declared by Siemens AG to comply with essential requirements and
other relevant provisions of the following EU directives:
• EN 60950-1
Information Technology Equipment – Safety – Part 1: General Requirements
40
RUGGEDCOM RSG2100
Installation Manual, 03/2020, C79000-G8976-1040-17

Siemens RUGGEDCOM RSG2100 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RSG2100
Category	Switch
Language	English