Siemens RUGGEDCOM RX1500 - Page 50

Modules
4.4Installing/Removing Power Modules
4.4 Installing/Removing Power Modules
The RUGGEDCOM RX1500 supports dual redundant power supply modules.
1
2
1
Slot PS1
2
Slot PS2
Figure4.4 Power Modules
NOTICE
Contamination hazard – risk of equipment damage
Prevent the ingress of water, dirts and other debris that may lead to premature
equipment failure. Always make sure slots are not left empty.
Note
Power modules are hot swappable. When installing/removing a power module, it is
not necessary to turn off power to the redundant power module.
Removing a Power Module
To remove a power module, do the following:
DANGER
Electrocution hazard – risk of serious personal injury or death
Make sure power to the module is turned off before servicing the power supply ter-
minal.
1. Turn off power to the module.
RUGGEDCOM RX1500
Installation Manual, 05/2020, C79000-G8976-1053-17
41