Certification
6.1.3FCC
6.1.3 FCC
This device has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference when the equipment is operated in a
commercial environment.
This device generates, uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instruction manual, may cause harmful inter-
ference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case users will be required to correct the
interference at their own expense.
IMPORTANT
Changes or modifications not expressly approved by the party responsible for com-
pliance could void the user's authority to operate this device.
6.1.4 FDA/CDRH
This device meets the requirements of the following U.S. Food and Drug Administra-
tion (FDA) standard:
• Title 21 Code of Federal Regulations (CFR) – Chapter I – Sub-chapter J – Radiolog-
ical Health
6.1.5 ISED
This device is declared by Siemens AG to meet the requirements of the following
ISED (Innovation Science and Economic Development Canada) standard:
• CAN ICES-3 (A)/NMB-3 (A)
6.1.6 ACMA
This device meets the requirements of the following Australian Communications and
Media Authority (ACMA) standards under certificate ABN 98 004 347 880:
• Radiocommunications (Compliance Labelling – Devices) Notice 2014 made un-
der Section 182 of the Radiocommunications Act 1992
• Radiocommunications Labelling (Electromagnetic Compatibility) Notice 2008
made under Section 182 of the Radiocommunications Act 1992
• Radiocommunications (Compliance Labelling – Electromagnetic Radiation) No-
tice 2003 made under Section 182 of the Radiocommunications Act 1992
• Telecommunications Labelling (Customer Equipment and Customer Cabling) No-
tice 2001 made under Section 407 of the Telecommunication Act 1997
RUGGEDCOM RX1500
Installation Manual, 05/2020, C79000-G8976-1053-17
53