Approvals
A
The SIMATIC NET products described in these Operating Instructions have the approvals
listed below.
Note
Issued approvals on the type plate of the device
The specified approvals apply only when the corresponding mark is printed on the product. You
can check which of the following approvals have been granted for your product by the markings
on the type plate.
Current approvals on the Internet
You will find the current approvals for the product on the Internet pages of Siemens Industry
Online Support (http://support.automation.siemens.com/WW/view/en/33118389/134200).
Notes for the manufacturers of machines
The devices are not machines in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 2006/42/EC for these
devices.
If the devices are part of the equipment of a machine, they must be included into the EU
declaration of conformity procedure by the manufacturer of the machine.
See also
SIMATIC NET Industrial Ethernet TP and Fiber Optic Networks (http://
support.automation.siemens.com/WW/view/en/8763736)
EC declaration of conformity
The SIMATIC NET products described in these operating instructions meet the requirements
and safety objectives of the following EC directives and comply with the harmonized European
SCALANCE XB-100
Operating Instructions, 02/2019, C79000-G8976-C473-03 45
To Next Page
Loading...
Need help?
General